Wire Cut CAM System - DXF-W
A wire cutting CAM system equipped with a variety of features and compatible with numerous manufacturers.
1. You can specify processing instructions for closed shapes, open shapes, coreless designs, and upper and lower irregular shapes. 2. For each shape, you can set processing patterns, processing conditions, number of processing cycles, and tapers. 3. Since combinations of processing patterns, processing conditions, and number of processing cycles can be made, plate processing data can be created as a single NC data. 4. You can approach any position of a closed shape. 5. The processing direction for multiple processing can be reversed. 6. By setting multiple residuals during multiple processing, high-precision processing can be achieved without leaving marks on the approach area. 7. Since cutting conditions can be set, it can accommodate polishing finishes in the approach area. 8. For the finishing of coreless processing, tapers and multiple processing can be set. Micro shapes that cannot have pilot holes can be approached from the outside for coreless processing. 9. Processing of upper and lower irregular shapes can be done for closed shapes and open shapes (multiple processing is also possible). 10. Partial conditions and partial tapers can be easily set.
- 企業：ネオ
- 価格：Other
